Yea its just the fact that its a tournilevel gun, in theory. This is most likely close to what i will use for a valve and ram. http://www.airsoldier.com:8080/cgi-bin/mivavm?Merchant2/merchant.mvc+Screen=PROD&Store_Code=AOS&Product_Code=SMC-SYJ3140-VG-X72-Q&Category_Code=SOLENOIDS The ram its self is...

A pressure vessel is a pressure vessel... 1800 psi is 1800 psi
so you can fill it that high. If your really unsure... give the guns at paintball technical institute a call.

Yes its gunna be oringed. The final run will be delrin.
The protype will be really ineffecient. Prob take alot of pressure

but the real one will be using a nice ram, and those run pretty efficiantly.

All ya need is to throw a ballvalve in the mix and your good!!

Air is supplied in the lower area. when the firing sequence is enitiated. a valve opens allowing air to push the piston forward. This allows the rest of the air to be released. The protype will be a one shot deal. it will have to be manualy recocked. On the real deal the bolt its self will be part o...

Haha yea this is turning into an iam conversation more then it is a forum conversation.

Some, for example, psp allows ramping up to 15 bps. Nxl allows full auto up to 15bps. Everyones different. Ive never seen uncapped ramping allowed at an event though... nor would i want to.... OK back to the idea... does anyone have any tips... there are alot of smart minds in this forum... does any...

The problem is that is a very hard question to answer. It all depends on pressure and flow efficiancy. we dont really know those variables.

If you are between the two i can deffianltly tell you that the co2 tank will hold more air.

Why make an electro paintball gun? Speed, Control, More modes, Intelligence. Manual guns are becoming more few and far between in the high end world. Other then pumps there are really not any tourni level electroguns. This gun is aimed to the low pressure, high cost, high ROF, high consistancy crowd...

Hahah its fine. I appreciate any imput at all!
I realize that some of the paintball stuff might be a bit confusing, just the termoligy. Just stick with me here haha.

I mentioned right above the picture. The actual gun, post protype model, will feature full electronics, 4 way valve, and 2 way ram. That way i can actuate the ram back and forth, all under computer control.

Super for the win!!!

I have decided to start the proscess of building a field worthy paintballgun thats more on the custom side. Origonaly i was gunna build a Spimmy(spyder body with intimidator internals) but i was turned of by the fact that they are just as expensive as a normal one... and i have never been overly imp...

5000, 4500 or 3000 psi?

thats gunna take a LONG time to fill btw...
buy two of those suckers... add a 2 check valves and tees