Difference between revisions of "Bushing modification"
| (5 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | Bushing modification refers to removing the stop built into a reducing or hub [[bushing]], so that a pipe may freely pass through. This is commonly done when fabricating [[coaxial]] cannons and [[piston valve]]s. | |
| − | + | Several methods exist that can be used to remove the lip from a bushing. One of the easiest ways is to use a Dremel or other rotary tool. Sandpaper or a file can also be used. | |
| − | + | ||
| − | [[ | + | The best method of doing this is to remove only portions of the lip at a time. Check the pipe inside the bushing periodically until it will fit. |
| + | |||
| + | [[Category:Construction methods]] | ||
Latest revision as of 19:46, 25 March 2009
Bushing modification refers to removing the stop built into a reducing or hub bushing, so that a pipe may freely pass through. This is commonly done when fabricating coaxial cannons and piston valves.
Several methods exist that can be used to remove the lip from a bushing. One of the easiest ways is to use a Dremel or other rotary tool. Sandpaper or a file can also be used.
The best method of doing this is to remove only portions of the lip at a time. Check the pipe inside the bushing periodically until it will fit.
