Quick Dump Valve

The Quick Dump Valve

The quick dump valve is a variation on a traditional barrel sealer piston valve. In the section on piston valves, various configurations are covered and the advantages and disadvantages of each. A quick dump valve may be used where the traditional valves shortcomings cause problems for the builder. It was noted in the piston valve section in the wiki that as a barrel sealer valve nears a 1:1 ratio, the pilot pressure needed to open the valve drops lower, and when they pop open, they do so with more force and speed.

Spool valves are balanced design valves with several o rings that move past ports and are operated by the rings crossing ports to join some in the same segment or separate them. They are noted for the ability to switch high pressures with little force to operate the valve. Typical uses are the hydraulic controls on heavy machinery such as a backhoe. Normal spool valves have both ends of the valve rod at atmospheric pressure.

A QDV when closed has the appearance of a spool valve. The air source under pressure is sealed off with an o ring on both sides of the port. What makes this different than a typical spool valve is when it is opened, the supply pressure is then applied to the end of the spool. This pressure provides a positive feedback to the spool so as it opens, the force opening it rapidly increases as supply pressure in the outlet port pushes on the piston.

Unlike a piston valve that uses pressure in a "Pilot" area to hold the valve closed, the QDV has no pressure on the pilot area of the piston to hold it closed. In this manor it is much like a spool control valve.

Article under construction.. More to come..