SpudFiles

Hi everybody!

I was wondering if anyone knew the pressure ratings on polly pipe?

For those of you who dont know what that is http://203.147.170.141/product_files/prd_109.jpg

i was just wondering because i've used it in all my guns and I wanted to know how safe it is.

http://www.tps.us/extras/OD.html has the dimensions
http://www.engineersedge.com/pipe_bust_calc.htm
Heres a nifty little working/burst pressure calculator.
http://www.isco-pipe.com/products_servi ... ypical.asp
Website with properties of material. The material strength i found was around 3200psi.
I'm sure theres a chart concerning this somewhere, but this stuff i found faster.
enjoy, I'm going to bed.[/url]

thanks so much man

3200psi, thats alot isnt it ? (i know its not the pressure rating or how much pressure it can hold)

Negative; 3200 psi is at the low end of the tensile strength range, even for plastics.
Many (non-foam) rubbers are lower, though.

16bar running pressure.