SpudFiles

I recieved my Taprite regulator in the mail today. It screws onto the CGA 320 threads of my 20oz CO2 tank fine, but I noticed it has no way to push down on the release valve of the CO2 tank.
Instead, the O-Ring of the regulator simply rests on the shoulder of the male threads on the tank.



Any suggestions would be greatly appreciated.

have you tried using it yet alot of the times stuff doest make sense then you use it and it does.

Yea, I think I've figured it out. The regulator wants an on/off valve, not the pin valves found in paintball tanks. At least this gives me an excuse to get a 10lb CO2 tank.

["gotmilk1124"]

i do