quick question
Posted: Sun Nov 25, 2007 12:13 am
What size of end cap fits in 1 inch sch 40 pvc pipe and 1.5 inch abs? I have tried .5 inch caps and they are to big.
Page 1 of 1
Posted: Sun Nov 25, 2007 12:16 am
uhh... yea... try hot glue or epoxy...
Posted: Sun Nov 25, 2007 12:24 am
i don't fully understand your question jon_89
Posted: Sun Nov 25, 2007 12:28 am
He wants to know what diameter PVC or ABS end caps can fit into 1" Sch40 PVC and 1.5" ABS. Though he failed to tell us what kind of ABS he is using. 
Posted: Sun Nov 25, 2007 12:32 am
i seeMrCrowley wrote:He wants to know what diameter PVC or ABS end caps can fit into 1" Sch40 PVC and 1.5" ABS. Though he failed to tell us what kind of ABS he is using.
Posted: Sun Nov 25, 2007 12:37 am
sorry the abs is solid core 1.5 inch.
Posted: Sun Nov 25, 2007 12:55 am
Well is this for pneumatic or combustion, cause if its pneumatic better make sure its pressure rated and it screws in. Can't glue ABS with PVC.
Posted: Sun Nov 25, 2007 12:59 am
I have a feeling he wants to use the end cap for a piston.TheTrooper wrote:Well is this for pneumatic or combustion, cause if its pneumatic better make sure its pressure rated and it screws in. Can't glue ABS with PVC.
Posted: Sun Nov 25, 2007 1:07 am
The 1 inch is pvc and is for my pnuematic and the 1.5 inch is abs and is for my combustion. I will be using the caps for a slug type ammo. It will be two encaps filled with something.
Posted: Sun Nov 25, 2007 7:53 am
I have never seen any pvc fittings smaller than .5", but you might want to try different sizes of cpvc fittings, since they are a little smaller than pvc.
Posted: Sun Nov 25, 2007 8:08 am
1/2 inch CPVC caps with a little modification fit into 1 inch pipe.
i know for a fact that 3/4 inch CPVC caps are s;ightly smaller than 1/2 inch PVC caps.
i know for a fact that 3/4 inch CPVC caps are s;ightly smaller than 1/2 inch PVC caps.
Posted: Sun Nov 25, 2007 4:23 pm
what about the 1.5 inch abs?