SpudFiles

Gun Freak wrote:What's the significance/gain of using a live center over a dead center?

A dead center is used in combination with a faceplate (instead of a jaw chuck) and lathe dogs. A dead center rotates with the face plate and work piece. A live center is used in the tailstock and allows the workpiece to freely rotate.

Thanks guys
Think one of these would work as a live center?
http://www.mcmaster.com/#ball-bearing-screws/=exosny

Probably not very well if at all due to the fact there is no point to hold the work piece centered.

velocity3x wrote:A dead center is used in combination with a faceplate (instead of a jaw chuck) and lathe dogs

I'd like to see how your setting that up.

jrrdw wrote:I'd like to see how your setting that up.

These are pics I found in the net. The last pic shows the dead center in the spindle bore of the lathe and a live center on the tailstock. The lathe dog is homemade. This setup is used for turning between centers. Turning between centers is how you make a crankshaft from a chunk of billet.

Probably not very well if at all due to the fact there is no point to hold the work piece centered.

Ah yeah you're right. Is it ok for us to be discussing lathes here or should I just stick with the Offtopic?

Gun Freak wrote:

Probably not very well if at all due to the fact there is no point to hold the work piece centered.

Ah yeah you're right. Is it ok for us to be discussing lathes here or should I just stick with the Offtopic?

This is the "Machinist" thread so it's ok.


@velocity3x
It's hard to see the dead center but I get how it works. I was searching Youtube (keywords: using lathe dogs) for that set up in action but didn't really come up with anything worth posting...

Ok, in that case, DIY lathe V3 in design stage.

abou the part earlyer, i wanted to make a sielencer for a qb78 air rifle. the barrel is 14.95mm od. do you think that making bushings to then slip a larger pipe onto the barrel be easy? i think im going to get a tube for the outside tommorrow.

turner wrote:do you think that making bushings to then slip a larger pipe onto the barrel be easy? i think im going to get a tube for the outside tommorrow.

It's a faily simple job, especially if you remove the front sight. Beware of ordering a complete silencer if you're in the US though.

New video is online for centering with a 4 jaw chuck. Enjoy.
[youtube][/youtube]

Don't know if this is the right section but does anyone have any good projects for a beginner machinist? I just got a small lathe for Christmas and I'm wondering what to make. Thanks in advance

sharpshooter11000 wrote:Don't know if this is the right section but does anyone have any good projects for a beginner machinist? I just got a small lathe for Christmas and I'm wondering what to make. Thanks in advance

1st project: Simple machinist jack. You need 2 bolts. 1 2X4 hex bolt and 1 9/16ths X 2 hex bolt. Chuck the 2X4 bolt and drill it for tapping the 9/16th threads. Screw them together and you just built a simple machinist jack.

Thanks jrrdw I'll make one of those tomorrow, once I figure out how to cut threads. Any simple spud gun sorta things?

Use a tap to cut the threads unless you have a really small boring bar lol.

Spudgun related: Pistons, smooth and true up cylinders, spark plugs for combustion's, customized washers and shims. The list can go on and on, it depends on what your building.

Ok moving this to this topic from the one I started..

Need some .25" round stock steel, preferably hardened steel, turned down to a point and a hole drilled in the back. Please give me an estimate on pricing per one unit, and I'll let you know how many I'll need.