SpudFiles

Hey,

Do any of you guys know of a workshop where I can send plans to receive machined parts in Canada?

I'd like to bring my canon to the next level

Thanks,
alex

ARE YOU SERIOUS

I should post a new sticky: "Please read stickies before posting a new topic"

...but no one would read it

@Gun Freak
thanks

@MrCrowley
i didn't know what keywords to look for, mainly due to some degree of language barrier and the massive size of your forums.

even if i did stumble upon that thread, there are 11 pages of mostly personal comments. plus, i want to know of a machine shop that is canada based so i can avoid Customs troubles.

do your feelings still hurt?

i didn't know what keywords to look for, mainly due to some degree of language barrier and the massive size of your forums.

Stickies are posted at the top of every forum section (but are section dependent, i.e. a sticky in the General section wont show up in the Construction section). You could spend 5 minutes now and quickly look at the topics with "Sticky" in their title posted near the top of every section just so you know what stickies we have.

even if i did stumble upon that thread, there are 11 pages of mostly personal comments. plus, i want to know of a machine shop that is canada based so i can avoid Customs troubles.

The point of the topic is to make a request. The machinists of this forum don't necessarily post their information in that thread. What you need to do is post a detailed drawing with relevant dimensions, what material you want it made from, for how much and any other information you can think of and then a member will reply and tell you if they will do it for you or not. Customs generally aren't an issue with custom spud gun parts (aside from silencers).

do your feelings still hurt?

Na, I was being sarcastic