Page 1 of 1
Will this mark on the fitting effect glueing
Posted: Thu Nov 08, 2012 11:50 am
by 8tonsemi
Will the mark effect the glue from adhering or damage the fitting?
http://imageshack.us/photo/my-images/51/img0004pne.jpg/
Posted: Thu Nov 08, 2012 12:10 pm
by jackssmirkingrevenge
which are the surfaces that you need to glue?
Posted: Thu Nov 08, 2012 12:39 pm
by 8tonsemi
The bushing shown in the picture will be glued into a 90degree elbow.
Posted: Thu Nov 08, 2012 12:46 pm
by jackssmirkingrevenge
... but the mark is on the outside, right? not actually on the surface where you will be applying the glue?
Posted: Thu Nov 08, 2012 12:48 pm
by 8tonsemi
It's a bushing so it's going to be going to into the elbow.
Posted: Thu Nov 08, 2012 7:02 pm
by grumpyoldman
You should be able to use it. There is a whole lot of surface area that is OK. That one small place won't matter.
Posted: Thu Nov 08, 2012 7:39 pm
by 8tonsemi
Thats Grumpy. I just chose to take a chance and do it anyway.
Posted: Thu Nov 08, 2012 7:45 pm
by mattyzip77
Don't worry about it.. Just a little messy where it came out of the mold...
