guy im thinkin about somthin like this [url] http://airgunartisans.com/AAHomemade2.htm[url] one right above pitbull
but in a 50 cal or a 45 cal
any ideas or i have the materials to do it but just wondering if youve done anything like it
Airgun homebuilding thread
Your Url is bad.guy im thinkin about somthin like this [url] http://airgunartisans.com/images/HomeMa ... 07.jpg[url][ /url]
"You can't be friends with anyone if you aren't friends with yourself."
"I'd rather be hated for who I am, than loved for who I'm not." -André Gide
Give me a lever long enough, and a fulcrum on which to place it and I shall move the world.
–Archimedes
Defeat is always momentary.
–Carl Denham
Current Project: None, I'm in Spudremission.
"I'd rather be hated for who I am, than loved for who I'm not." -André Gide
Give me a lever long enough, and a fulcrum on which to place it and I shall move the world.
–Archimedes
Defeat is always momentary.
–Carl Denham
Current Project: None, I'm in Spudremission.
- inonickname
- First Sergeant 4
- Posts: 2606
- Joined: Sun Dec 07, 2008 3:27 am
Aluminum, brass and steel, with a HPA reservoir.
Do you have a machine shop to do this with twizi? It's no mean feat..do you also have the facilities to rifle the barrel?
Do you have a machine shop to do this with twizi? It's no mean feat..do you also have the facilities to rifle the barrel?
PimpAssasinG wrote:no im strong but you are a fat gay mother sucker that gets raped by black man for fun
Re-URL-ed
http://airgunartisans.com/images/HomeMa ... %20007.jpg
Unless you have a machine shop, all you can do is think about it.
http://airgunartisans.com/images/HomeMa ... %20007.jpg
Unless you have a machine shop, all you can do is think about it.
Ok please be nice if i am wrong..
but couldn't you just make a valve like the hammer valve in Gippeto's co-ax ??
could you get a piece of solid ally drill your center hole 3mm and then drill your port in the side. place 2 o'rings either end of the solid and a grub screw hole in the middle between the orings then slide the valve down into your chamber and grub screw it in place. (ruff version)
then all you need is a snug fit pipe/tube to go between your valve and breach ?
the hardess part i think would be the seal , all real pcp guns use (sorry to all but most) delrin plastic as there seal. i think this could be possible
here are some excamples, from real pcp guns
but couldn't you just make a valve like the hammer valve in Gippeto's co-ax ??
could you get a piece of solid ally drill your center hole 3mm and then drill your port in the side. place 2 o'rings either end of the solid and a grub screw hole in the middle between the orings then slide the valve down into your chamber and grub screw it in place. (ruff version)
then all you need is a snug fit pipe/tube to go between your valve and breach ?
the hardess part i think would be the seal , all real pcp guns use (sorry to all but most) delrin plastic as there seal. i think this could be possible
here are some excamples, from real pcp guns