SpudFiles

Its a double barrel shotgun:.

1/8'' cal double barrel shotgun
total length 2.45''

The stock is pine.
barrels are made from 1/8'' stainless steel rod stock
trigger guard is brass
Butt plate is the rubber i use to seal my piston valves.
Trigger is a 1/16'' piece from the leg of a resistor. 8)
Pics:





What do you think?

And no, it does not actually shoot.

Note: Mods, if this is in the wrong section, please move to the appropriate one. Thank you.

Lolz thats pretty cool... I might have to try that.
Too bad it can't shoot

Cool but Ive seen a mini combustion that was only one inch, it was made from part of a straw hot glue and a piezo ignitor, it was fired once

Thats pretty good! Time to get some propane metering on that bad boy.

Moonbogg wrote:Thats pretty good! Time to get some propane metering on that bad boy.

For the win!

Maybe propane metering in the next (full auto ak47) version. lol.

This was made for my fiancee. She is a sculptor, and asked if i would make a 2.5'' in shotgun as a prop for one of her models.

Needless today, she was very happy with it, as am I.

Good things happen when you do what the one who must be obeyed commands!
:sex:

NICE! It'd be awesome to make a coaxial out of this!

Looks great, though personally I'd thin out the stock a little bit.

Darn you, you've inspired me.

Not bad

inonickname wrote:Darn you, you've inspired me.

Same here, I have 0.04" BBs now...

MrCrowley wrote:Looks great, though personally I'd thin out the stock a little bit.

i tried. but the barrels are almost touching... about a single piece of papers width apart... and there is no room to thin out the stock without the barrels hanging over.

@JSR.

I need to see you do that. It would make me very happy.

side note.... im trying to build a co-axial inside a .243 cal rifle round... with no successes. It seems there is no room for a piston
Any ideas?

Your fiancee asked you to make her a shotgun?
definitely marry this one buddy!


Could you make a miniature hacksaw to go along with it...just for me?

And no...I'm not on the market..

I have made guns for little action figures when I was a kid..
I think I may still have one.

It's smaller...and it's a 4 barreled shotgun...
The game is on!

it doesnt shoot??
awwwww

BTW its not near the smallest

I was just about to holler for the JSR challenge, but apparently I am a bit too late...

This little gun is so cool. Even though I am typically a fan of very large guns.