Page 1 of 1
My soon to be drone
Posted: Sun Jun 06, 2010 2:33 pm
by Demon
Here is where i am currently, there is a 11 pages thread on
www.patator.frbb.net but you guys cant see it
Posted: Sun Jun 06, 2010 2:36 pm
by kydavies
nice, your from Quebec?
anyways i tried to make a glider drone that would be shot out of 1.5" PVC barrel...
my first 3 prototypes failed horribly... lol
Posted: Sun Jun 06, 2010 2:41 pm
by Demon
anyways i tried to make a glider drone that would be shot out of 1.5" PVC barrel...
my first 3 prototypes failed horribly... lol
Why?
Did you use sch40? i use drain waste 4" (much lighter) so it makes for a 1.9 meter wingspan
Je vis à montreal ...
Posted: Sun Jun 06, 2010 2:45 pm
by kydavies
cool im from BC.
my "drones" were really ghetto they were designed to fit inside my cannon which has a 1.5" (41mm) barrel that is 20" long. the drone was intended to fin inside the 1.5" barrel and be only 6"-12" long and glide several hundred feet.
NEW DESIGN
my new design is meant to be fired up several hundred feet and stream video while parachuting down. i suck with electronics and computers so i will get some one else to do that part for me
Posted: Sun Jun 06, 2010 3:06 pm
by Demon
..... Good luck
Posted: Sun Jun 06, 2010 3:38 pm
by qwerty
Very nice but, you havent got a tail fin and the wing are under horizontal.
Posted: Sun Jun 06, 2010 4:07 pm
by Demon
It is not done yet, i need to do various little things but the base is done