SpudFiles

i have a 3.5 hp briggs and straton engine it is has a vertical shaft and i want to make it a horizontal shaft. would it work if it was turned sideways i already tryed tipping it forward and when that happend all this smoke came out and it freaked my parents out would it work on its side?

depends if its a 2 stroke or a 4 stroke, a 4 stroke wont work on it's side, a 2 stroke SHOULD

its a 4 stroke someone told me if i posision the carb upright it would work is that right

use a tough rippled hose

When you turn the engine sideways ,the oil which normally stays in the bottom end ,is now dispersed through the engine and the oil will now not be picked up by the oiler .(whichever type it uses) The engine could run this way but it will not run very well or for very long.

ok can you think of a way to angle the shaft so it makes horizontal

modify a small car diff,or use some bevel gears somehow. i would not personally tip it up the wrong way,if u want a horizontal shaft,buy an industrial motor

dude those lawn mower engines arent the best but good for explosions

what???
u can blow it up

if u put nitrous in it ...........or propane,or acetalene........or put a short fuse in the fuel tank.....see plenty of ways to blow it up

i didn't want to blow it up just wonderin why you would want to blow up an engine

because its fun

ok... good point!!

make a huge spodgun and chuck the motor down there........or just shoot the piston out of it.......

dude u need a 90degree anle gear. you will have to custom order it because nobody sells them. I have the same problem but my dads a mechanical engineer so he cna help me out. Im makeing a gokart out of a lawn mower. and no you cant turn it sideways