I have a problem with my piston. It seals perfectly (Barrel Sealer). But when I open t he BV (Exhaust) it dont seat back, so, all the air goes throught the BV instead of barrel. Tried a lot of pressures (20psi or 150psi), even blowing air throught the BV (the piston seals the barrel), but when I blow air throught the chamber side of the "Tee", all the air goes throught the BV.
Any suggestions/solutions?
Specs:
- 3/4in "Tee"
- 1/2in "Barrel"
- 1/2" Ball Valve
Pics:
** The back seat and o-ring. This is a 3/4" to 1/2" reducer.
![Image](http://img6.imageshack.us/img6/6466/dsc00336m.th.jpg)
** At background (inside the Tee), the 1/2" Fitting (Barrel)
![Image](http://img23.imageshack.us/img23/9631/dsc00337siq.th.jpg)
** Piston housing (chamber side view).
![Image](http://img27.imageshack.us/img27/7122/dsc00338vfm.th.jpg)
** Piston Housing "Full View".
![Image](http://img16.imageshack.us/img16/992/dsc00340toe.th.jpg)
** Piston Housing, BV (without handle), fill part.
![Image](http://img41.imageshack.us/img41/459/dsc00339tvc.th.jpg)
** Full view, without barrel.
![Image](http://img43.imageshack.us/img43/2324/dsc00341ciq.th.jpg)