Paintball sniper

[Moggle NZ]

just a picture of the setup i might use just wondernig what i can in pvove on such as
metirals
airflow
just any thing

when u pull the bolt back the ball valve will open
and close when u push formards so u can have muliple shots





wh

[jrrdw]

Looks like your air will be restricted. That's good for repeated shooting but bad for power.

[Gun Freak]

Not a very practical design. There are easier ways to do it. Why a hammer valve and a ball valve?

[Moggle NZ]

that is why i posted it asking for halp then u just tell me whats bad not tell me what i can do to impove it

[Gun Freak]

1. Too much dead space

2. Bolt is overly complex

3. Make the air chamber one part (not two with a ball valve)

I would like to say though that the actual valve part looks doable with a little creativity. But, what pressure are you going to use? It will take a lot to get paintballs flying.

[Moggle NZ]

ok thanks gun freak i was thinking instead of a valve useing a solenoid valve is
15mm an ok size
or shud i opt for the bigger 25mm
i would prefur the smaller 1 for look reasons only

[Gun Freak]

I'm no sure you can get multi-shot on a ssolenoid valve... Have you given thought to a three-way valve?

[Moggle NZ]

you can ive seen it done b4

[Moggle NZ]

is a 15 mm solenoid valve an ok size for this gun?