.Depending on size of your Tee housed piston you want to build,use your imagination.Coke bottle lids,buttons glued together etc.Use your brain not your wallet.
Piston valves
-
rna_duelers
- Staff Sergeant 3
- Posts: 1739
- Joined: Mon Sep 26, 2005 7:07 am
- Location: G-land Australia
Think outside the box,do you actually need a glue gun to use the glue sticks?Hell no,get yourself a baked bean can (empty) chop up some glue stick and hold it over a candle,use pliers it will get hot .
Depending on size of your Tee housed piston you want to build,use your imagination.Coke bottle lids,buttons glued together etc.Use your brain not your wallet.
.Depending on size of your Tee housed piston you want to build,use your imagination.Coke bottle lids,buttons glued together etc.Use your brain not your wallet.
End caps sometimes fit flush inside a coupler so you could try that.
Technician i'm interested in how you connected the HDPE to the drill press if the hole didn't go all the way through the piston?Technician1002 wrote: A short picture tutorial is below.
Never take life seriously. Nobody gets out alive anyway.
-
inonickname
- First Sergeant 4
- Posts: 2606
- Joined: Sun Dec 07, 2008 3:27 am
He tapped a hole and threaded in a bolt which had the head cut off.
PimpAssasinG wrote:no im strong but you are a fat gay mother sucker that gets raped by black man for fun
-
Technician1002
- Captain
- Posts: 5189
- Joined: Sat Apr 04, 2009 11:10 am
I made a hole just a little smaller than the bolt and force screwed in the bolt and cut off the head. Then I chucked the bolt into the drill press. The hole in the piston goes just past 1/2 way through. The bolt tapped its way in. No tap needed.M.J.P. wrote: Technician i'm interested in how you connected the HDPE to the drill press if the hole didn't go all the way through the piston?