SpudFiles

This is my latest creation. I decided to make a piston valve using entirely out of poly pipe fittings. I think the gun itself turned out quite well. I wanted to make something that could be pulled apart and stuck into a bag, but I also wanted to be able to change the barrel/chamber of the gun. It's just about finished. I had a blowgun actuating it and it worked quite well, but I want to add a modded sprinker valve and add a small stock.

Anyway, enjoy .

(It still needs a bit of a clean up...)

Looks really good mitchza. The new barrel(hopefully longer) will improve performance a lot. What pressures do you run it at?

Good looking, nice simple gun. What are you using for ammo

nice one mate!!

gotta love bunnings

Cheers alot guys. I plan to run it at 200+ psi so it should have a fair bit of kick. I've got a 1m barrel that I'll use marbles for. I'm happy with it .

good work!

looks good

Thanks mate.

paintball barrel + 50psi should be safe

50psi in a gun like that? That's child's play But as far as actual paintball goes, 50psi should get me velocities close to a paintball gun.

that was what i meant.. you can have a nice war

spudfarm wrote:paintball barrel + 50psi should be safe

this stuff is poly pipe mate, its good to 500

Very nice, and at elevated pressures the performance should really be something, los damage pics por favor!

ohh you don't ynderstand

if you use just 50psi you can use it just like a normal paintball gun

spudfarm wrote:ohh you don't ynderstand

if you use just 50psi you can use it just like a normal paintball gun

lol ah k getcha now

but if you want to obliterate something you go high

500psi?! Damn... I didn't know this stuff was rated that high. I saw a sticker on a piece of poly (not the one I got) but it said only 1750kpa I mean that's bloody terrible...

I've got a coax bb gun that uses a 600mm piece of 1/2'' poly, and it's holding perfectly at 300psi so I'm not sure

Cheers for all the comment's lad's