Page 1 of 1
with a piston or without a piston
Posted: Sat Jul 19, 2008 9:39 am
by drunkii
on this pic you see a pneumaticp gun
but what is the difference with the piston , or without the piston?
goes it faster with piston ?
and can you install something on your pneumatic gun that loads the chamber with air or another fuel automatically?
without a pump or a compressor?
ty people
Posted: Sat Jul 19, 2008 10:01 am
by FishBoy
I'm not sure what your asking.
Posted: Sat Jul 19, 2008 10:54 am
by Leonard
That kind of design would NOT work without the piston. If you're looking for performance, build that piston type of launcher. Here's a very helpful page on pistons :
http://www.spudfiles.com/forums/piston- ... t8157.html
The other option you are speaking of, if i understand correcly, would be to put the Ball valve between the chamber and barrel, so that the ball valve would work as the main valve. This kind of setup would work and be easy to make but will be weak. I would recommend you to read more, do more research, and go for a pîston when you feel ready.
Posted: Sat Jul 19, 2008 3:49 pm
by Ragnarok
Leonard wrote:That kind of design would NOT work without the piston.
Actually, it would be a miracle to get that particular set-up to work at all.
The barrel sealing face is far too far forwards, which would prevent the valve from opening at all - that sealing face needs to project in at least slightly further than the side arm on the Tee to have any chance of working.
Posted: Sat Jul 19, 2008 4:45 pm
by Biopyro
Just thinking ahead of you here, If you're planning a piston gun as your first, forget it. Go for a nice simple ball valve then move from there.
To help you understand pistons check out this thread
http://www.spudfiles.com/forums/piston- ... t8157.html
Pistons are by no means easy. It took me quite a while to get my first piston to work, and even now I have problems with it.
Posted: Sat Jul 19, 2008 5:15 pm
by judgment_arms
Why go ball valve?
‘Round here you can get a 1 inch jar top for the same price as a 1 inch PVC ball valve…
First gun, go with an unmodified sprinkler valve, simple but effective.
Learn exactly how and why a piston valve works before you try and make one, otherwise you’ll probably end up with a paperweight…
By the way, Ragnarok, it’s been awhile since I nagged you last about the LRC, so…
Is it done yet?! 
Posted: Sat Jul 19, 2008 5:22 pm
by MrCrowley
Sorry for the diagram but I really didn't want 13year old kids running around the streets with a golfball gun, there is enough information in my how-to so you can make a piston and the cannon, but you'll have to do some research.
I'd prefer if the people running around with golfball guns had some clue to what they were doing and haven't just got the plans of the net.
Rag is right, it'd be difficult to get that design to work at all, but if you put your mind to it, it really shouldn't be hard for you to figure out how to build it. That diagram was more or less to show the layout of the gun IIRC, not how the piston works. Look at the animations or my other how-to, that actaully has most information, if not all, correct in it.