my new plinker gun.
Posted: Tue Aug 19, 2008 9:34 pm
This is just a throw-together gun i made to make use of the new barrels i recently made. It uses a 1 inch irritol sprinkler valve, standard stuff.
The sleeved golfball barrel was a pain to make, i cut very small slivers out of a piece of 2'' pipe with a table saw, until it just fit into the other 2'' pipe. once i got it in there about five inches, i just pounded the crap out of that thing until it was in there all the way. Unfortunately, i was left with a small gap in the inner barrel. I filled it with low viscosity epoxy and it turned out great!
The paintball barrel was much easier, i just drilled out a hole big enough for the paintball to fit through, and i used a bored out coupler for the bolt.
The golfball barrel is my new favorite barrel, it puts golfballs out of sight.
The sleeved golfball barrel was a pain to make, i cut very small slivers out of a piece of 2'' pipe with a table saw, until it just fit into the other 2'' pipe. once i got it in there about five inches, i just pounded the crap out of that thing until it was in there all the way. Unfortunately, i was left with a small gap in the inner barrel. I filled it with low viscosity epoxy and it turned out great!
The paintball barrel was much easier, i just drilled out a hole big enough for the paintball to fit through, and i used a bored out coupler for the bolt.
The golfball barrel is my new favorite barrel, it puts golfballs out of sight.