SpudFiles

Hello everyone, I was wondering if I would use the "generic valve" input for a 3/4 Orbit Water Master Sprinkler valve that is modded with a 1/4" blowgun with no dead space. Cause the sprinkler valve is modified with a blowgun attached by a nipple right to the sprinkler valve. So what would i put for a valve seat diameter? and the dead volume, flow eff., and dwell time?

Any help would be appreciated!

Sure, you could do that. But considering that the Orbit Water Master is explicetly discussed on the GGDT webpage, I'd think you a fool should you choose to use "generic valve."

Moral of the story: RTFM.