SpudFiles

hi all you air gun lovers im back with my 2nd gun mad its pretty much goes back to my other gun that i made when i was 14 and it worked great had no problemssimple ball vavle 1 shot so yeah thats it
so heres the gun video at the bottom






[youtube][/youtube]

[youtube][/youtube]

[youtube][/youtube]

For small calibres, you should consider using higher pressures. The ball valve is perfect for dealing with these pressures, all you'd have to do is make sure that your chamber and fill valve can take the strain. With a schrader valve and a relatively cheap shock pump, you can go to 300-400 psi in a small chamber in less than a minute, and you really will see the difference.

Also, not sure if the "suppressor" is functional, but remember, there's no substitute for cubic capacity when it comes to effectiveness

jackssmirkingrevenge wrote:For small calibres, you should consider using higher pressures. The ball valve is perfect for dealing with these pressures, all you'd have to do is make sure that your chamber and fill valve can take the strain. With a schrader valve and a relatively cheap shock pump, you can go to 300-400 psi in a small chamber in less than a minute, and you really will see the difference.

Also, not sure if the "suppressor" is functional, but remember, there's no substitute for cubic capacity when it comes to effectiveness

hey thanks man yeah still gotta make a air tank for it so i can connect to the back

how does your trigger mech/ spring catch work, kinda hard too see

Lockednloaded wrote:how does your trigger mech/ spring catch work, kinda hard too see

hi yeah its just a simple spring loaded ball vavle with a latche you pull the latch like on a real gun with releases the spring which pulls down the ball vavle pretty simple work good too

Looks great. can i asked what you used for the barrel?

Stolly32123 wrote:Looks great. can i asked what you used for the barrel?

hi thanks 4 the comment and yeah its a 10mm aluminium barrle