Page 1 of 1
O-ring detent
Posted: Wed Feb 23, 2011 10:14 pm
by nadjatee1996
How do I make one? Sandwich an o-ring between two pipes and in case it in a nipple? I also read somewhere that I can cut two slits top and bottom of the pipe and then put an o-ring in the slits
Re: O-ring detent
Posted: Wed Feb 23, 2011 10:29 pm
by jackssmirkingrevenge
nadjatee1996 wrote:How do I make one? Sandwich an o-ring between two pipes and in case it in a nipple?
That's one way of doing it, though encasing it between a nipple and a socket is a better idea because it makes it
adjustable
I also read somewhere that I can cut two slits top and bottom of the pipe and then put an o-ring in the slits
Primitive but also adequate for most use.
Posted: Wed Feb 23, 2011 11:14 pm
by nadjatee1996
Is it OK of the ID of the tube and the ID of the o-ring is the same?
Posted: Wed Feb 23, 2011 11:42 pm
by jackssmirkingrevenge
It depends on which system you're going for. If the o-ring isn't going to be compressed, it should be smaller than your barrel I/D to be effective.
Posted: Thu Feb 24, 2011 12:33 am
by nadjatee1996
Errrr...I'll be using 3-rings for my valve, and 2 o-rings for my barrel, whichis compressed and which isn't" Which needs to be what size?
Posted: Thu Feb 24, 2011 12:40 am
by Crna Legija
all you need to do is make sure there is a peace of rubber holding you ammo back until pressure can make is pop out, theres a lots of ways of doing it, now use brain and suprize us
Posted: Thu Feb 24, 2011 12:44 am
by nadjatee1996
Fine -_-
Message is now long enough
Posted: Thu Feb 24, 2011 5:33 pm
by Gun Freak