HellHound build log

Show us your pneumatic spud gun! Discuss pneumatic (compressed gas) powered potato guns and related accessories. Valve types, actuation, pipe, materials, fittings, compressors, safety, gas choices, and more.
nadjatee1996
Specialist
Specialist
Posts: 185
Joined: Mon Jan 03, 2011 7:20 pm

Sat Mar 05, 2011 9:56 pm

Ladies and gentlemen, I present to you..the HellHound build log...

Top Frame/Magazine[][]
Middle Frame/Barrel[][]
Bottom Frame/Air tank [][x]
Valve[x]
Trigger[]

EDIT-Added first batch of pictures

Air tank, the end caps are made of solid epoxy putty
Image

Valve Diagram
Image

Valve
Image

Valve Open
Image

Valve Closed
Image
nadjatee1996
Specialist
Specialist
Posts: 185
Joined: Mon Jan 03, 2011 7:20 pm

Sun Mar 06, 2011 1:20 am

Umm..Can a mod put this in the right section?I'm not really sure where this belongs
User avatar
jackssmirkingrevenge
Five Star General
Five Star General
Posts: 25836
Joined: Thu Mar 15, 2007 11:28 pm
Has thanked: 157 times
Been thanked: 94 times

Donating Members

Sun Mar 06, 2011 1:25 am

nadjatee1996 wrote:Umm..Can a mod put this in the right section?I'm not really sure where this belongs
It is the right section.

Workmanship looks a bit shoddy but pretty is as pretty does, good luck :)
hectmarr wrote:You have to make many weapons, because this field is long and short life
nadjatee1996
Specialist
Specialist
Posts: 185
Joined: Mon Jan 03, 2011 7:20 pm

Sun Mar 06, 2011 1:34 am

Yea, I screwed up on the top seal so I had to re-epoxy, as you can see the bulge. I also had to cut out the 2 middle sections from larger pieces of flat epoxy I made. I might sand it all off later to give it a nice look. Theres also epoxy behind every seal so it won't fly off. R.I.P the pen I sacrificed for the spring inside
Post Reply