SpudFiles

Posted: **Sat Mar 05, 2011 9:56 pm**

Ladies and gentlemen, I present to you..the HellHound build log...

Top Frame/Magazine[][]
Middle Frame/Barrel[][]
Bottom Frame/Air tank [][x]
Valve[x]
Trigger[]

EDIT-Added first batch of pictures

Air tank, the end caps are made of solid epoxy putty

Valve Diagram

Valve

Valve Open

Valve Closed

Posted: **Sun Mar 06, 2011 1:20 am**

Umm..Can a mod put this in the right section?I'm not really sure where this belongs

Posted: **Sun Mar 06, 2011 1:25 am**

nadjatee1996 wrote:Umm..Can a mod put this in the right section?I'm not really sure where this belongs

It is the right section.

Workmanship looks a bit shoddy but pretty is as pretty does, good luck

Posted: **Sun Mar 06, 2011 1:34 am**

Yea, I screwed up on the top seal so I had to re-epoxy, as you can see the bulge. I also had to cut out the 2 middle sections from larger pieces of flat epoxy I made. I might sand it all off later to give it a nice look. Theres also epoxy behind every seal so it won't fly off. R.I.P the pen I sacrificed for the spring inside