Page 1 of 1
pcp fitting?
Posted: Fri Aug 12, 2011 11:09 am
by sco77
Are the PCP quick disconnect fitting (like on pcp pumps) the same standard QD fitting or is there anything special about them?
Posted: Fri Aug 12, 2011 11:10 am
by Gun Freak
They are different, rated for higher pressure and easier to disconnect at high pressure.
Posted: Fri Aug 12, 2011 11:18 am
by Lockednloaded
You can also get them with check-valve built in. Theyre easier to disconnect because of the smaller SA, but I'd still recommend some sort of bleed valve that you can open to disconnect
Posted: Fri Aug 12, 2011 11:49 am
by jackssmirkingrevenge
There are some brand specific connectors (for example I need
this probe for my FX) but most are identical to those used in the paintball industry, you can buy them quite cheaply off eBay.
Posted: Fri Aug 12, 2011 11:48 pm
by sco77
Lockednloaded wrote:You can also get them with check-valve built in. Theyre easier to disconnect because of the smaller SA, but I'd still recommend some sort of bleed valve that you can open to disconnect
The PCP pumps I have looked at all had a bleed valve on it so that's not a concern..
