Page 1 of 1
qev exhuast to elbow?
Posted: Tue Mar 05, 2013 6:19 pm
by speedballs
Is it OK to run my barrell like this? Have used two of these same elbows on my bv plinker(pix posted on "greetings from speed balls") they have given me no worries cranking out 200psi.. am I safe? It will be right near my.. hmm eye!
Posted: Tue Mar 05, 2013 6:30 pm
by Zeus
Yeah, that's no problem. Assuming it's steel, it'll handle anything you can chuck at it. 800 psi is no concern.
Posted: Tue Mar 05, 2013 6:44 pm
by speedballs
Its a brass gas fitting. Rated at 400psi I think. The gas and water sealant I use seems to bond a little better to brass.
Posted: Tue Mar 05, 2013 6:47 pm
by Zeus
Should still be fine then, it's not likely to explode on you.