88g regulator
Posted: Fri May 24, 2013 6:36 pm
Hey all. Does anyone know if there's a way to regulate the output of an 88g disposable co2 capsule?
Page 1 of 1
Posted: Fri May 24, 2013 6:52 pm
This will allow the 88g cartridge to connect to paintball threaded (ASA) equipment. From there you can plug it into a regulator, such as the Palmer Female Stabilizer which I highly recommend.
Posted: Fri May 24, 2013 7:57 pm
X2 for the Palmers reg...good piece of hardware.
I will add that the 88gram cartridges are THE most costly form of CO2 available. If you intend to regulate, then you'll most likely end up with an asa thread somewhere...far better off IMO to take the jump to a refillable CO2 tank as well. Will save you some coin in the long run.
Your choice though.
I will add that the 88gram cartridges are THE most costly form of CO2 available. If you intend to regulate, then you'll most likely end up with an asa thread somewhere...far better off IMO to take the jump to a refillable CO2 tank as well. Will save you some coin in the long run.
Your choice though.
Posted: Sat May 25, 2013 4:24 am
Thanks for the info guys. I'll see if I can get the project up and running with 88g's then maybe look at purchasing a co2 tank. If it works 
. Thanks again
. Thanks again