SpudFiles

I consulted with a member of this forum Wyz2285 and he said i need to replace the air blower gun with some other thing to Increase the power i have no idea what to use instead of the air blower gun and maintain the shape of the Grip (I've considered using PVC ball valve but the problem was it wouldn't look like a Barrett M82A2 anymore) I thought i could join and get some help from the members who are keen to help noobs like me.. :hello2:
I'll post the specs if anybody needs them to get an idea on what I'm trying to make

One thing you can do is just take the blow gun apart and drill the port a bit bigger. A fairly small change in the diameter of the whole increases the air flow significantly.
http://www.spudfiles.com/spud_wiki/inde ... dification

Some gas systems (like stoves etc.) have these Y-shaped connectors used with a flow restricter. This would allow you to have like an "in-line" piston valve with as small as possible blowgun mounted on something like a wooden grip, voila!

Jimmiy101 ,lets say i have a blower gun like this ,now where am i going to drill?
Jakethebeast can you attach a picture of the Y-shaped connector ?

Ill try to find it from my shop tomorrow after my geology exam

See the button that the handle pushes? See the hex nut? Remove the nut and open the valve up. Drill/grind/sand to boost the air flow.

Roger that lieutenant

Roger that lieutenant

It's Lieutenant General

but your more than general, at least thats what i think the red stars mean

Sorry for the delay, but this kind of fitting would allow the same ergonomics :


Chamber side


Piston side

Thanks JTB i'll see what i can Do...
The gun will be completed on 2014