hot glue piston

maz oner · Tue Jan 30, 2007 4:32 am

Ive made a piston by chopping up hot glue sticks into little pieces and put into a piece of spare copper tube, (chamber size) then heated the whole thing up with my blowtorch

untill it all melted now i cant get it out of the tube, its glued in like glue (as it is)
how does every one els take them out without cutting the tube
i might go heat it up a little so the outside melts a but then push it out but any help greatly appreciated

arigato
maz 1

Check out my YouTube SpudGun Channel! · Tue Jan 30, 2007 5:03 am

You forgot to use non-stick or baking paper didnt you

Mr.Russ · Tue Jan 30, 2007 5:11 am

Hehe I bet he did forget

chaos · Tue Jan 30, 2007 5:46 am

maybe try lightly reheating the outside lol should have used that non stick baking paper

Mr.Russ · Tue Jan 30, 2007 6:05 am

you could put a metal rod down the tube and whack it on the ground

maz oner · Tue Jan 30, 2007 8:57 am

nah i used baking paper on the bottom but not the sides but i heated the outside and it just droped out the i put it in my chamber and it was an exact fit ... i also finished silver soldering my gun together and s#!t is it powerful also i didnt know that hot glue seals the berrel aswell so no neoprene for me

cheers

maz

SpudBlaster15 · Tue Jan 30, 2007 2:06 pm

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.