NSF-pw & NSF-dwv?
Posted: Wed Feb 14, 2007 9:39 pm
Iv got sum 2" SCH40 pipe and i want 2 make a coaxal pneumatic and the pipe say NSF-pw and NSF-dwv. Is it safe? and thanks for any help i get.
Page 1 of 1
Posted: Wed Feb 14, 2007 9:48 pm
its perfect
Posted: Wed Feb 14, 2007 10:41 pm
rely im not guna die thank so much cuz now i no that im not guna die 
.
.Posted: Wed Feb 14, 2007 10:49 pm
As long as it says nsf-pw on it your good, ignore the dwv label.
Posted: Wed Feb 14, 2007 10:53 pm
frankrede, don't screw with him. Th3popo, if you use that pipe, you will die.
...if you used a cardboard tube, you would die. You could even use SCH 160 welded aluminum, and you would definitely die. Everyone dies eventually
...however, you will probably not die as a result of this pipe exploding. Just make sure to follow the proper solvent welding directions, and only use your spudgun with proper temperatures and pressures
...if you used a cardboard tube, you would die. You could even use SCH 160 welded aluminum, and you would definitely die. Everyone dies eventually
...however, you will probably not die as a result of this pipe exploding. Just make sure to follow the proper solvent welding directions, and only use your spudgun with proper temperatures and pressures
Posted: Wed Feb 14, 2007 10:53 pm
ok will do and thank you very much.
Posted: Wed Feb 14, 2007 11:02 pm
well this isn't my first gun iv made allot of them about 6 combustgen guns and 1 penumatic that i made out of DWV parts and its gone all ready so don't worry.
Posted: Thu Feb 15, 2007 1:01 am
bit off topic but salad fingers kicks ass
Posted: Thu Feb 15, 2007 2:54 pm
wy yes it dos 
and i got all the parts 2 day woot i cant wait to put it all together. any tips or suggestions? any more help that you all give me thank you 
and i got all the parts 2 day woot i cant wait to put it all together. any tips or suggestions? any more help that you all give me thank you