Page 1 of 1
my idea for marble mg mag
Posted: Fri Mar 09, 2007 9:28 pm
by mopherman
i thought that, maybe you could have a mag on the bottom of the barrel and use the vented air from your pilot valve to push the marbles up and into the barrel. think it could work?
Posted: Sat Mar 10, 2007 2:25 am
by Brian the brain
I had thought of that too but the pilot runs out pretty quick..But then again...if you do it like that you'll have a closed system, so when the valve opens, air will be flowing from the mag back into the pilot and close the valve..
In theory it could work true full auto..but most likely, you'll end up with a honker....
Posted: Sat Mar 10, 2007 7:50 am
by spudthug
yea it wil probly honk alot....it may work though....go for it!!
Posted: Sat Mar 10, 2007 9:42 am
by mopherman
Brian the brain wrote:I had thought of that too but the pilot runs out pretty quick..But then again...if you do it like that you'll have a closed system, so when the valve opens, air will be flowing from the mag back into the pilot and close the valve..
In theory it could work true full auto..but most likely, you'll end up with a honker....
im guessing you know what your talking about, thanks for the feedback. im making a marble mg and im looking for a simple NON GRAVITY FED mag for realy fast fire.
Posted: Sat Mar 10, 2007 9:51 am
by VH_man
Just go with gravity fed....... its easier.......
Posted: Sat Mar 10, 2007 9:53 am
by mopherman
I just dont like the idea of the marbles falling out if i move the gun
Posted: Sat Mar 10, 2007 10:02 am
by VH_man
I know how to stop that. have you ever seen the whole barrel assembely of an airsoft gun? the only thing that stops all the bb;s from flying out the barrel from a gravity fed hopper is the hop-up. pretty much, just slap a thin peice of craft foam on the top of your barrel right in front of the breech. also, this increases accuracy and range, due to the fact the marble is spinning in one direction AND it has a backspin. this spin actaully makes the projectile shoot more level and much straighter. try it!
Posted: Sat Mar 10, 2007 10:04 am
by mopherman
so just put in the top section of my barrel?
Posted: Sat Mar 10, 2007 1:48 pm
by VH_man
yeah, in the very first part of it. just a little tiny square will probaobly do it. make sure its on the top thoug.........
try making a square the size of your marbles. that should work.
TEST before you stick it on your actual gun. dont want to mess that one up....
Posted: Sat Mar 10, 2007 3:03 pm
by mopherman
Brian the brain wrote:I had thought of that too but the pilot runs out pretty quick..But then again...if you do it like that you'll have a closed system, so when the valve opens, air will be flowing from the mag back into the pilot and close the valve..
In theory it could work true full auto..but most likely, you'll end up with a honker....
man, what are we gonna do without you
good luck in holland