I was on a skateboard with no wheels, lol, so basically a snow board with grip tape and no bindings and I went down a ramp (like the first time in years) and the board slipped sideways and I fell onto the box and I hit the metal thing you grind on with my arm (coping I believe it's called)... And my Arm was really fucked up, it went straight, then bent down, then up again (where it went down by my wrist you could fit a whole softball in.... Well if I woulda went 1 more inch down it would've ripped off my wrist basically...djt wrote:jeeze that doesnt sound good. how do you get your arm almost severed in a skateboarding accident?? sounds like a story i would like to hear!
but anyways couldnt he just screw in the screws for the electrodes all the way in so there is nothing sticking out on the outside of the chamber? instead of all this tapping and glueing stuff.
On topic: Do what Shrimphead said, you can't just put epoxy in a hole and expect it to hold, either go to home depot and buy a 1/4" plug and drill a hole and put that in with Epoxy or JBWeld, or else get a bolt with a nut and a washer and put the head of the bolt inside or put the washer + nut inside and JB Weld that into the gun...