Help me with darts plz
reedfe wrote:Soo I need some darts for my 1 in pneumatic. It's got breech loading and u would prefer some easier to make nail darts
look into the how to section
dont play with airsofter with 1000$ gun and play with a 5 dollar pair of glasses
-
FighterAce
- Specialist 2
- Posts: 295
- Joined: Fri Oct 23, 2009 1:28 pm
- Location: Croatia/Zagreb
- Has thanked: 1 time
- Been thanked: 4 times
- Contact:
I made a video on how to make them, here take a look http://www.youtube.com/watch?v=t4EhauBKfCQ
If you dont have a printer, its not a big deal. You can either make a template and then just draw it on paper or copy it from the monitor.
I personally use the template technique because you can fit 8 darts onto 1 A4 piece of paper compared to 3 printed ones.
I wouldn't use them over 10 bar with a fast opening valve cause the paper could explode. If you want more pressure then you can use thicker paper or saturate the paper with wood glue so it becomes more rigid. Or... my personal favorite, combine the 2.
Good luck!
btw. I didnt post my darts into the how to section
If you dont have a printer, its not a big deal. You can either make a template and then just draw it on paper or copy it from the monitor.
I personally use the template technique because you can fit 8 darts onto 1 A4 piece of paper compared to 3 printed ones.
I wouldn't use them over 10 bar with a fast opening valve cause the paper could explode. If you want more pressure then you can use thicker paper or saturate the paper with wood glue so it becomes more rigid. Or... my personal favorite, combine the 2.
Good luck!
btw. I didnt post my darts into the how to section
-
inonickname
- First Sergeant 4
- Posts: 2606
- Joined: Sun Dec 07, 2008 3:27 am
Oh god, don't make us do this to every one of your posts.twizi wrote:So I need some darts for my 1 in pneumatic. It's got breech loading and I would prefer some easier to make nail darts.reedfe wrote:Soo I need some darts for my 1 in pneumatic. It's got breech loading and u would prefer some easier to make nail darts
look into the how to section
For nail darts I use(d) nozzles from caulking tubes. You can grab a handful from the hardware store. Cut them down using a stanley knife (boxcutter) and trim as required. You can even sand them if you want. Then simply force a nail through the inside of the tube through the nozzle tip.
They may not fit a 1" barrel. Have a look around.
PimpAssasinG wrote:no im strong but you are a fat gay mother sucker that gets raped by black man for fun
-
boyntonstu
- Sergeant
- Posts: 1039
- Joined: Sun Jun 28, 2009 8:59 am
Full ‘quiver’ of nail darts. 10 Gauge wads and corks.
The cork cutting and shaping is getting better each time.
My shooting range behind my friend’s farm.
I shot 3 holes through the plywood in a 6” circle without sights.
Next project: Sights
Check these Chrony nail dart results:
http://www.airgununiverse.net/community ... 8.html#new
The cork cutting and shaping is getting better each time.
My shooting range behind my friend’s farm.
I shot 3 holes through the plywood in a 6” circle without sights.
Next project: Sights
Check these Chrony nail dart results:
http://www.airgununiverse.net/community ... 8.html#new