ok im updating this.
i have an idea how to pressure water make a hose hook up to a check valve then a copper pump. water fills pump and then you push down goesa through a second check valve and into the gun until it is high pressure.
2nd idea dis assemble a pressure washer handle to a fitting hook the fitting to the gun then pressure the gun. like a 2400 psi one. will that be way to high pressure?
just some ideas
high power squirt gun
- spudtyrrant
- Corporal
- Posts: 550
- Joined: Fri Jan 02, 2009 6:10 pm
lol, might as well just buy a pressure washer i don't know why you think that you can make, or even pump for that matter a 2400psi pump. especially out of copper
copper is usually rated for 3ksi or more. I would like to submit an alternate design, one built by D_Hall (the guy with the massive 29" bore hybrid)
linky
linky
POLAND_SPUD wrote:even if there was no link I'd know it's a bot because of female name
- Technician1002
- Captain
- Posts: 5189
- Joined: Sat Apr 04, 2009 11:10 am
The amount of energy needed to provide a stream at that pressure is very high. This is why most pressure washers are several horsepower.spudtyrrant wrote:lol, might as well just buy a pressure washer i don't know why you think that you can make, or even pump for that matter a 2400psi pump. especially out of copper
Water under very high pressure forced through a small orifice rapidly breaks up in air. Ever notice that you can squirt further with a garden sprayer than you can with a pressure washer? Most pressure washers are unable to squirt water further than about 20-25 feet. The water stream breaks up into fine mist.
Anything over 250 PSI is a waste of pressure. Larger orifices help, but then you need a firetruck pump of several hundred horsepower.