SpudFiles

Whats everybodies thoughts?

Well, you can select a favorite really. ABS is for combustion uses, while Pressure Rated PVC is for pneumatic purposes.

One thing I have noticed about ABS is that it smells like burning synthetic material when you do anything to it. I mean if you file/dremmle/sand it, it just smells awfull!
It's also really soft and scratches easily.

PVC, on the other hand, smells like hot corn oil and is not [as] soft.

abs doesnt make any smell, and no dust when cut

pvc smells like deas anus when cut or burned, the dust is horrible

abs handles shoke VERY well

pvc shatters

abs looks tough and thick

abs kicks butt

I beg to differ, I I was cutting a project box made from ABS with a dremel, and the fumes were terrible. If you ask me, ABS is the one that smells like "deas anus".

PVC does shatter and create dust, but it's much stronger when it comes to pressure apliccations. If you ask me, PVC is better.

i agree, even though i havent used abs much(only once) but it uh........... lets say broke. the barrel sorta seperated from the chamber upon detonation, and flew about 20 ft farther than the spud. my opinon is that pvc solivent welds better,and abs is bad

I know Im going to get made fun of vut I use abs for every, thing even pressure tanks i know it sounds stupid but i have tested it extensivly and it has never failed me. haha it was so funny watching those park rangers try to brake that big gun!

If it works I guess, I mean, I would'nt use ABS unless its a combustion cannon, but I'd probably just use PVC, its cheaper here.