Page 1 of 1
Burst Disk Materials
Posted: Sat Feb 18, 2006 3:30 pm
by <_SLAYER_>
Hi, I'm new to burst disks (currently use a 3" ball valve on my pneumatic, which sucks for efficiency!), and I was wondering what the best materials to fit in the union are, and what approx. pressures I could get out of them before they blow up. Any idea's?
Posted: Sat Feb 18, 2006 4:03 pm
by boilingleadbath
Register with the spudtech.com forums... In their hybrid section, they have a "burst disk sticky" about 5 pages long.
Posted: Sun Feb 19, 2006 1:16 pm
by <_SLAYER_>
thanks a lot
Posted: Sun Feb 19, 2006 3:47 pm
by nicholai
why doesnt this site have something like that?