Page 1 of 1
Neoprene Substitute
Posted: Sat Jul 26, 2008 11:36 am
by Counterstriker
Last night I was out for about an hour and a half going from store to store looking for neoprene for my small coaxial.. No one seems to have it..I even went to an Beer distributor for Beer Coolies and they were out.. Any idea what to use? I used Inner tube before but it's not stiff so it won't seal correctly. Any Idea? Thanks

Posted: Sat Jul 26, 2008 11:39 am
by Hubb
Get a rubber washer. I got one from a radiator cap. Also, a tub stopper should work.
Posted: Sat Jul 26, 2008 11:42 am
by Counterstriker
hubb017 wrote:Get a rubber washer. I got one from a radiator cap. Also, a tub stopper should work.
Will it work for a 4.5 barrel? I had that problem with my last coaxial..

Posted: Sat Jul 26, 2008 12:18 pm
by Gippeto
Have you considered tire patches?
Posted: Sat Jul 26, 2008 12:54 pm
by Counterstriker
No , I am not sure about the rubber type material because it tends to be to stiff to seal the barrel of for a small cannon like this one.
Posted: Sat Jul 26, 2008 1:14 pm
by TurboSuper
How about butchering a neoprene pot holder?
Posted: Sat Jul 26, 2008 1:25 pm
by noob of noobs
I hear some mice pads work as long as they aren't porous.
And do you mean a 4.5 inch barrel?
Posted: Sat Jul 26, 2008 1:28 pm
by Fnord
Go to a tire shop and ask if they have any scrap tractor inner tubes. If you can't make a trip there then look for stuff like floormats, or the mats you put in the car. Apparently you can use leather if it's fairly smooth.
Posted: Sat Jul 26, 2008 1:31 pm
by Counterstriker
noob of noobs wrote:I hear some mice pads work as long as they aren't porous.
And do you mean a 4.5 inch barrel?
4.5 MM.
Posted: Sat Jul 26, 2008 2:36 pm
by frankrede
Piece of basketball?
Posted: Sat Jul 26, 2008 2:45 pm
by Counterstriker
OK, turns out all I needed was under my hand the whole time.. The mouse pad.. Thanks guys and thanks Noob of noobs.