Page 1 of 1
How did you go about cutting your breech hole?
Posted: Thu Feb 12, 2009 10:52 pm
by jmeyer1022
I'm breech loading golf balls and I was wondering how you guys cut your holes. I'm sure most people will say they used a core bit drill or along those lines, I was wondering if anyone used something different.
Posted: Thu Feb 12, 2009 10:59 pm
by frankrede
Dremel, Hacksaw?
Posted: Fri Feb 13, 2009 12:25 am
by roboman
Dremels work great.
Posted: Fri Feb 13, 2009 2:56 am
by inonickname
Dremel, mitre saw, jigsaw, hacksaw, router, holesaws. Whatever you want.
Posted: Fri Feb 13, 2009 11:02 am
by FishBoy
coping saw has not been mentioned
Posted: Fri Feb 13, 2009 11:32 am
by Brian the brain
Your other GB cannon?
A bbmg??
You can use whatever you got.
Just make sure the hole has no square angles, this may weaken the pipe.
Keep the hole as round as possible.No point for a tear to start from...
Posted: Fri Feb 13, 2009 11:33 am
by trae08
bandsaw jigsaw sawzall rotozip
whatever you can do it with dosnt have to be anything certain. just cut the hole and clean it up with some sand paper.
Posted: Fri Feb 13, 2009 4:15 pm
by maggotman
on my copper cannon i made the breech buy holding it up to a bench grinder
Posted: Fri Feb 13, 2009 4:45 pm
by Sticky_Tape
Dremel with (I think carbon) cut off disk(s). Win.
Posted: Fri Feb 13, 2009 7:30 pm
by psycix
CNC milling machine, laser cutting, plasma gun vaporising, antimatter annihilating, just anything that is in your reach and can cut the material can be used!
Posted: Fri Feb 13, 2009 7:42 pm
by dudeman508
Since i dont have any electric cutting tools i used a hack saw to cut two holes and then went over the other cut sites with a nife a bunch of time then bent it of with plyers.