SpudFiles

Posted: **Mon Mar 15, 2010 1:10 am**

Is it possible to cast low-viscosity epoxy resin into a mold and taking it out of the mold?

P.S. Like perhaps putting a layer of grease onto the surface of the mold before casting the epoxy so that you could slip the harden epoxy out of the mold after it is cured.

Posted: **Mon Mar 15, 2010 1:18 am**

*cough cough*

Posted: **Mon Mar 15, 2010 1:32 am**

BRILLIANT. 8)

Posted: **Mon Mar 15, 2010 9:14 am**

Not only that but they have "casting epoxy" made specifically for that purpose.

Posted: **Wed Mar 17, 2010 8:36 am**

I belive that the casting epoxy that you are refering to is a ployester resin and in that case I would saythat you are better off using JB weld or a similar epoxy for tha sake of your piston's durability.

SpudFiles

Casting Epoxy from Molds

Casting Epoxy from Molds