i dont think this will work too well, but if your not looking for something which is super effective, but instead something which is easy to build, then this is for you.
this build is so ridiculously easy its not funny, it took me less than 5 mins!
this will fit a 10 mm barrel well but may also fit a 6mm barrel.
step 1: Make sure its empty, or you will end up like me.... smelling real pretty like...
step 2: Take a small hammer and hit that top blue shaft, you will hear some gas being released
step 3: take a small drill bit to make a pilot hole, maybe 4mill, drill the hole at the top and at the bottom
step 4: clean the inside, and take out the mechanism
step 5: drill a 10mm hole in the top and the bottom.
Thats it


**fitted to my rifle**


my rifle isn't sealing right now, otherwise i would make a video showing its effectiveness