SpudFiles

Posted: **Wed May 24, 2006 7:34 pm**

I know, this is a stupid question ...

How does the air go on the other side of the piston (in ther camber) ?

Posted: **Wed May 24, 2006 7:37 pm**

your right, it is a stupid question
the piston is not sealed, when somebody make a barrel sealing piston valve, they allow a small leak between the pilot and the chamber.

Posted: **Wed May 24, 2006 7:39 pm**

saladtossser wrote:your right, it is a stupid question
the piston is not sealed, when somebody make a barrel sealing piston valve, they allow a small leak between the pilot and the chamber.

I dont understand ...

Posted: **Wed May 24, 2006 8:11 pm**

The only airtight part is against the barrel, theres just enough room between the piston and the chamber wall for air to get through, sometimes poeple put small holes in the piston to leak it through there. Hope that helps.

Posted: **Wed May 24, 2006 8:32 pm**

Atlantis wrote:The only airtight part is against the barrel, theres just enough room between the piston and the chamber wall for air to get through, sometimes poeple put small holes in the piston to leak it through there. Hope that helps.

ok thank you

soooooo simple

Posted: **Thu May 25, 2006 12:13 am**

yea, i had trouble how the hell that worked at first too.