SpudFiles

So I have a spare gas-powered leaf blower laying around. I was thinking about the way that vortex-style airsoft guns operate, and was wondering if a leaf blower (Being a very high-volume but low-pressure air source) could power one. My idea is to build a 3-barreled vortex block, powered by a leaf blower, with the vortex block and barrels enclosed in a length of 4” pipe. Here’s a rough sketch of my idea.
I figure since I already have the leaf blower and 4” pipe, all I need is some bondo, ball valves, and barrel material.
Let me know if you think the high-volume idea is bullcrap and won’t shoot very far.




Peace,
Pete Zaria.

The barrels would have to be next to each other,not on top of each other or else one barrel will get all the ammo and the others would just let air escape.

You better use your mouth.The presure will be much grater.

Maybe if you funnel the air before the vortex, it will make the pressure higher.

Rambo, have you ever used a gas leaf blower? The average models blow the air 200 mph. I think it will work fine.

OK, so it seems like the concept will work.

If you guys wouldn't mind helping me fine-tune the design a bit before I build it, that'd be great.

I plan to have the three barrels in a tight triangle (touching eachother), each tapped into the vortex block.

Should the air enter the vortex block from the bottom, or from the side facing the engine?

What's the best way to cut off the flow of BB's (when you want to stop firing)?

How big should the vortex block be? I'm going to make a 4" x 4" "plug" out of bondo to carve the vortex block out of.

What size pipe is correct for 6mm airsoft BBs?

Do you forsee any problems in building this?

Thanks a ton, everyone.

Peace,
Pete Zaria.

6mm airsoft bbs fit almost perfectly in brakeline.

What size brakeline?

Peace,
Pete Zaria.

OK,if you want 3 barrels then you have 3 different chambers with a vortex in each.That will give you the best preformance.You will have to custom design a special vortex block to get your first idea to work.(because you would have to get the flow right for the barrels)

5/16 brake line i think (wat im using at least)

you got the vortex block all wrong... and if u want three barrel side by side, they have to be on a horizontal plane

won't the ammo just be used by the outer 2 barrels, how would you make a vortex block like that, wouldnt it lose its integrity, pretty sweet idea though with a leaf blower you wouldnt have to carry around an air compressor then

use a cloud:
Cloud:
Pros: easy to build, just as effective as a vortex, no parts need replacing.
cons: cant think of any.
Vortex:
pros: they look cool.
cons: parts need replacing, not as effective as cloud, hard to build.

Thanks for the replys, guys.

Care to draw up a quick mspaint sketch of a leaf blower-powered cloud BBMG?

Peace,
Pete Zaria.