Sch 80 use.
Posted: Sat Sep 02, 2006 6:12 pm
I have just aquired 20' of 1.5" sch 80 and ~6' of 2" sch 80. What chould i use it for.
Page 1 of 1
Posted: Sat Sep 02, 2006 7:21 pm
A big, high pressure pneumatic.
Posted: Sat Sep 02, 2006 7:29 pm
2" is not big....
Posted: Sat Sep 02, 2006 7:34 pm
A small Hybrid would be cool. I saw one once and it was really powerful.
Posted: Sat Sep 02, 2006 7:59 pm
how bout a barrel 20' long and a chamber 6' long with a 3" piston or something? or make a co-ax
Posted: Sat Sep 02, 2006 9:28 pm
Not sure if you know this crowley, but the ID of 2" sch 80 is 1.913" and the OD of 1.5" is 1.9", which doesn't leave too much chamber space for a coaxial. 
(not laughing at you)
Cement an end cap on each end, put in a schrader and a pressure guage, and pump it up til it explodes! (Hopefully you were hiding behind something.)
(not laughing at you)Cement an end cap on each end, put in a schrader and a pressure guage, and pump it up til it explodes! (Hopefully you were hiding behind something.)
Posted: Sat Sep 02, 2006 10:28 pm
i dont think it will explode with a bike pump but it probablly would with unregulatted co2
Posted: Sat Sep 02, 2006 11:39 pm
noname wrote:Not sure if you know this crowley, but the ID of 2" sch 80 is 1.913" and the OD of 1.5" is 1.9", which doesn't leave too much chamber space for a coaxial.
Cement an end cap on each end, put in a schrader and a pressure guage, and pump it up til it explodes! (Hopefully you were hiding behind something.)
LMFAO i did not know that
so a chamber with a .013" dia isnt bad 
its not the extreme over here the worst ive seen is the 40mm pipe with a I.D of 43mm 
.gay thing is they make fittings for 50mm pipe O.D and 50mm I.D and its hard to find the right ones 
