Hi, Ive had this design, in my head for at least a year now, and Ive finally found the parts I need for it. I would be very grateful for any comments on how I can improve it. The Expansion chamber will be made of 5 mm thick PVC that has two seals on the outer rim of the PVC piston.
Almost all the internals will be made of copper.
New semi auto chamber design:maybe full auto later
-
- Specialist 2
- Posts: 233
- Joined: Fri Feb 09, 2024 1:58 pm
- Location: central city arkansas
- Has thanked: 55 times
- Been thanked: 7 times
- Contact:
nice work could use some improvement though still but then again any spudgun can never be good enough to be the ultimate spudgun