Page 1 of 1
New semi auto chamber design:maybe full auto later
Posted: Sun Oct 15, 2006 6:22 pm
by upit14
Hi, Ive had this design, in my head for at least a year now, and Ive finally found the parts I need for it. I would be very grateful for any comments on how I can improve it. The Expansion chamber will be made of 5 mm thick PVC that has two seals on the outer rim of the PVC piston.
Almost all the internals will be made of copper.
Posted: Sun Oct 15, 2006 7:03 pm
by upit14
I found every piece I need at home depo, Im thinking it can stand maybe 90+ psi
Re: New semi auto chamber design:maybe full auto later
Posted: Thu Feb 15, 2024 2:46 pm
by quinn whitsitt
nice work could use some improvement though still but then again any spudgun can never be good enough to be the ultimate spudgun
Re: New semi auto chamber design:maybe full auto later
Posted: Wed Sep 25, 2024 9:06 pm
by JaniceJMurphy
Using a PVC expansion chamber and brass internals sounds promising. I'd be interested to see how it performs under pressure.
Re: New semi auto chamber design:maybe full auto later
Posted: Tue Oct 15, 2024 4:50 am
by NateOnyx
Have you thought about how the seals will hold up over time, or if any adjustments will be needed to handle wear and tear?