SpudFiles

Do you think that it would be possible to make a pnuematic spudgun with a set of different sized screw on barrels? If it is could you give me some ideas or better yet plans. I think that if I had a good sized chamber that I could have a large selections of barrels to use. I hate having to be limited to one size of ammo for one gun. Any thoughts or suggestions would be awesome. Thanks

Hey welcome to the forums!
To answer your question, yes, not only is it possible it has been done.
Take a good look around here you should be able to find somethin.

Thanks a Bunch. Do have any useful thread links or websites that would have the relvent information. Again Thanks

here a coper one that might give u a few idears (its a very nice gun) http://www.spudfiles.com/forums/viewtopic.php?t=4084& 8)

Just have a say 2" Femal adapter on the gun, for each barrel get a 2" male adapter and the required reducers to he barrel.

Here you go.

http://www.advancedspuds.com/interchangable.htm

yes, of course It's possible, and has been done many times before. look at almost any piston gun.