Page 1 of 1
How to make the best union.
Posted: Tue May 31, 2005 1:30 pm
by rsgpit
I made a small union, but you have put the burst disk between the threads of the piping. Is this right?, or is there a better way to make a union.
Also, would a spring loaded mechanism that pops the burst disk work?
Posted: Tue May 31, 2005 1:34 pm
by iamthewalrus
y r u goign to make a union, jsut buy one
Posted: Tue May 31, 2005 1:35 pm
by rsgpit
You can buy them? Oh then that makes life much easier. Thanks alot
Posted: Tue May 31, 2005 2:11 pm
by CS
You need to go to Home Depot and take a short tour of there PVC fitting section. I dont follow you on the spring operated mechanism that pops your burst disk. Please explain a little more.
Posted: Tue May 31, 2005 2:29 pm
by rsgpit
Right after the union, im gonna bond a hinge to the inside of the barrel, and attatch a bolt or nail to the hinge, and then attatch a spring to the hinge, and i'll drill a small hole in the barrel, and attatch some cable to it, and you pull it back and let go, and it pops the union.