Page 1 of 1
3/8" Drill Bit
Posted: Tue Jan 16, 2007 10:44 pm
by MrCrowley
Ive googled this but google was wrong....
I need a drill bit to tap 3/8"(10mm) threads, Google said 16mm but google was wrong its about 1mm out, Can you get 15mm drill bits? Is that what I need?
Posted: Tue Jan 16, 2007 11:07 pm
by SpudBlaster15
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.
Posted: Tue Jan 16, 2007 11:10 pm
by MrCrowley
nah steel, about 2mm thick
Posted: Tue Jan 16, 2007 11:41 pm
by SpudBlaster15
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.
Posted: Wed Jan 17, 2007 12:23 am
by pyrogeek
My machine tech teacher had some posters up as to what size bit to use for what tap. Would there be anything like that online for people to reference from?
Posted: Wed Jan 17, 2007 12:36 am
by MrCrowley
Yeah there is, Thats what I found on google, it recomended a 16mm bit. Its too big so im going to try get either a 14mm or 15mm drill bit.