SpudFiles

1. any size wye fitting larger than 2'' and reduced to 1.5'' (smallest possible to fit a stungun.)
2. and peice of pipe and cap the size of the reduced wye.(for grip)
3. a stock can be made into the rear of wye or caped.
4. a flush bushing the size of your wye. (this goes toward the barrel of gun.)
5. a pressure rated plug the size of your reduced outlet in the flush bushing.
6. a hybrid ignition system coil setup ( can be found in Boogiemans hybrid cannon in the official forums.
7. shave the plug with the hex end so it fits into a fitting on both sides.
8. tap through the shaved end of plug to get the ign. coil into the chamber and glue the shaved edge into the flush bushing.

((((MAKE SURE FACTORY EDGE IS IN THE CHAMBER!!!!!!!!!!!!)))))

A picture would be nice...

this is from the newly redesigned SM-2


that pic show the ign coil through the plug that is in the sch80 union(factory edge) the shaved edge is in the wye. the coil is 3/4 cu couplings around a 1/2'' sch80 nipple. this pic is the wye, handle, stock, and switchs.
the 90 on the end has a cap on the bottom of it that fits flush to one another and inside is a test cap in the peice of pipe connecting the two fittings and hidden in the test cap is the main power switch to the stungun. it then goes to the missle toggle on the stock.

how this for a privates engineering? this concept is completely origional except for boogiemans coupling and nipple combo. got to give the man his credit it is only fair. though im am sure he'll be proud of what i done with it. the SM-2 is going to utilize a multi barrel setup up to 3''. the main barrel will be a 2'' sch 80 riffled bouncy ball barrel. it will be filled using a schrader valve with a wand thingy w/ a ball chuck will be the metering system. not got that far yet though. the chamber and barrel should be arriving in a few days or so. SORRY FOR MULTI POSTING BUT I COULDNT FIGURE OUT HOW TO POST TWO PICTURES.