Page 1 of 1
in need of basic assistance
Posted: Fri Jun 08, 2007 9:11 am
by Sir Muffin
im designing a new pneumatic rifle but im havin a little trouble thinking of a quick way to release my ball valve. any suggestion would be great!
Posted: Fri Jun 08, 2007 9:14 am
by veginator
you could make it spring loaded so you just hold it in place or make so some type of pin release. hope this helps.
Posted: Fri Jun 08, 2007 9:40 am
by pyromaniac
you can also add a bigger lever by screwing on some half inch pvc to the ball vlve handle.
Posted: Fri Jun 08, 2007 11:10 am
by chickenking
use a gate style valve (example:blowgun) they make larger ones not sure on pressure rating though